We start off with this corner:
...and apply detail, so:
Other side, same deal (MOST of these are going to be mirror objects. I'll note the ones that aren't):
Next, we add this piece to the front:
Up top (aft) go the next two:
On these, make sure to note which way up they go.
This one hangs over the edge; this is by design.
Next come these two.
Now these half-cylinders. Note the tapered side is aimed forward.
Next come these two little strips (again, pay attention to orientation):
Now these details go on next to them:
Now the little "arm" detail goes on the side shown.
This part is very delicate, and can be difficult. I'd be very careful with it, and you may want to keep it in place while the glue does its thing.
This bit goes on the corner shown.
...and this detail goes on the opposite side.
Another extra-thin detail goes in the place shown:
And this bit goes so it's going into the part we added previously (there isn't one for the other side, interestingly; I can't help but suspect there might have been at one time on the original prop, but it probably got knocked off or something).
Finally, this little detail goes on in the direction shown.
Well, that's mostly it. It's looking a lot better now, but you'll notice there's at least 4 holes waiting for stuff to add on. I'm sure we'll attend to them in good time.
No comments:
Post a Comment