Issue 99

 OK, gonna finish off the aft engine block (at last!), so first off, let's do some detail work.

First off, the rear ..whatever these are called again.

Now a little something I whipped up last week, printed in different sizes so I'll be able to compare them against the model.

Finally, it's time to finish off the last couple things for the bottom. First off, we assemble the lower turret to match the upper one.

Next, we glue these two bits together.

They go in this bit under the port mandible.

Here's what my finished underside looks like without landing gear.

Now to the engine block. Add the following glue-ons:

Note this is mislabeled in the magazine--it shows 6 as 7 and vice-versa.

And then go ahead and add the 13...whatever they ares. Presto.

Now the deflector shield generators will finish off this issue.

Each large part gets two sides glued to it, as shown:

They go onto the mandibles as shown below:

Next time, big issue 100, and lots of last-minute details.